Search models, users, collections, and posts
Gerald Gnome
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
9.8 h
1 plate
Open in Bambu Studio
Boost
16
43
0
0
5
0
Released
Description
3" tall Gerald gnome from the beloved cartoon show about Australian pups!
If opening in a differently slice here are the general tips:
- Tree Supports work best; if your supports are dialed in the “butt” supports will peel right off.
- Paint the front of the hat with the seam tool so the seam will NOT be generated there
- 10% + 2 wall loops is about as low as you want to do before the hat starts to become a little too brittle for my liking. It's fine for sitting on a desk, but if you have kiddos, leave it at 10%.
- There are 297 filament changes across 7 colors, tune your purge settings!
Also available for print here:
https://printingsquid.etsy.com
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)