Search models, users, collections, and posts
Dumpling Sewing Pattern Weight
Print Profile(2)
0.16mm layer, 3 walls, 15% infill, NO AMS
Designer
1.6 h
3 plates
0.16mm layer, 3 walls, 15% infill
Designer
4.6 h
1 plate
Open in Bambu Studio
Boost
39
161
1
0
42
20
Released
Bill of Materials
List other parts
- Washers x 5: 2" wide by 1/4" tall
Description
One washer is just not enough to keep your sewing patterns flat! Upgrade with these adorable, functional dumpling pattern weights. Designed to be heavy enough for denim yet smooth enough for silk, these weights use a pause at the top of a cavity to seal metal washers inside a 3D-printed shell.
This profile was tested on a the Bambu P1S and includes pre-set pauses to allow you to drop the washers in (I found it helpful to also lower the bed, which I did manually.)
Hardware needed:
- metal washers with a 2” diameter. The internal cavity is 7.2mm tall. I put in 5 washers that were about 1.2mm thick. This left tolerance for the nozzle to bridge over the washers.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (1)