Search models, users, collections, and posts
Basic Hueforge Stand
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
46 min
1 plate
Open in Bambu Studio
Boost
2
2
0
0
2
1
Released
Description
I wanted to create my own stand for HueForge prints. It uses 10% infill, 5 bottom layers, and 6 top layers. Tested fine with prints up to 200x200 (as well smaller ones) as shown by the attached pictures. You are welcome to sell the printed versions. If you make adaptations, please allow others to do the same if you post a derivative.
Boost Me (for free)
A boost would be greatly appreciated, but not necessary. Thank you!
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)