Statue Base

Hey Guys! I originally disgned this for family christmas games and then desided to share it with you guys! You may have nodiced that there is two different models. This is because one has a rectangle opening and a circle opening. (This purely so that this model is applicable to more people.) I also included 7 different tag-lines for both stands.the tag-lines can easily slide in/out very easily therefore I do recommend plastic glue for this model.Also the round-holed base only has a STL because I lost The 3MF file😂😂😂! But it is still reliable! Infact, only 4_12ths of the pictures had the rectangular opening😂😂😂! As always, make sure you have all of the following preparations made:

1.Clean plate with warm water and then thoroughly glue your plate with any type of glue you would normally  use (if you don't have glue already,I recommend Elmers Glue because it's cheap and it works. (This helps with adhesion).

2.Make sure your printer is lubed-up. (this helps with clean lines). 

3.Finally make sure you also do Flow Dynamics AND Flow Rate calibration. (This also helps with clean lines on the side AND top).

If you have any questions feel free to ask them in the comments.

Please download, like, comment, print, rate and boost if you have any😊🙏🏼.

Hope you Guys love printing this as much as I did,

                                                                                          Mr. Fresh Prints