Samurai Champloo

Project: SUNSET.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 230x129.38mm in size
You may print at higher layer heights below the Base Thickness of 1.12mm
The Max allowed Thickness is 2.88mm and the Actual Thickness is 2.88mm

Filaments Used:
    #061717 PLA Bambu Black  Transmission Distance: 0.1
    #d40021 PLA Elegoo Red  Transmission Distance: 3.7
    #ff6a13 PLA BambuLab Basic Orange  Transmission Distance: 5
    #ffffff PLA Bambu White  Transmission Distance: 6.2
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #16 (1.36mm) swap to Red
    At layer #23 (1.92mm) swap to Orange

Border Only Colors from here until the end.
    At layer #28 (2.32mm) swap to White

This slider is set higher than the mesh depth.  It is not affecting your final mesh.  Consider removing it.
    At layer #37 (3.04mm) swap to Black for the rest.