Search models, users, collections, and posts
Multi Locking Rod Holder
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% gyroid infill
Designer
47 min
1 plate
Open in Bambu Studio
Boost
8
16
6
2
22
11
Released
Bill of Materials
List other parts
- Cable Tie x 1: 1 per Holder
Description
Content has been automatically translated.
A simple holder for the locking rod on your multi-cycle.
Use two holders per rod and secure them with a zip tie as shown in the pictures.
The holder uses two holes in the basket, and the zip tie should go through the holes next to the holder, so the entire setup uses four holes.
Printed in Black PLA at 16mm layer height (Optimal print profile) with 15% gyroid infill.
---
A simple holder for the locking rod of the muli cargo bike.
Use two holders per rod and fasten them with a cable tie as shown in the pictures.
The holder covers two holes in the basket, and the cable tie should go through the holes next to the holder, so the entire fixture uses four holes.
Printed with black PLA, 16mm layer (Optimal Print Profile) with 15% gyroid infill.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)