Check out my new gauge pod design!

Check out my new gauge pod design!

Check my Sun2000 KTL-L1 coolers!

I modelled in Fusion this 3D part to convert my Ender 3 Pro to direct Drive. I know there are lots of this 3D parts, but you know, it is funny to do it yourself. Full instructions and lot of install photos. Yo don't need to buy any extra parts.

I made a simple and minimalist stand for my Stomvi Titan Seis french horn but is suitable for other brands and models Its made in two pieces and then glued together with loctite. You can print it in one piece, but you need too much supports and the finish is not as clean. I printed it with four perimeters to make it strong and 15% infill.

A simple sink hole cap, it works in approx 20mm sink drains. I attach the f3d too if you need to change the size. It's made in PLA and prints without any support in about 10 minutes at 0.1 layers

I made a 100x82 cm Neon LED RGB Honda logo for my garage wall. It's modelled in Fusion and uses about 10 meters of neon led strip. The strip is cutted to lenght into three pieces and they are connected in parallel. I used a zigbee rgb controller connected to Home Assistant with Zigbee2MQTT. It's splitted into 16 pieces and glued together with loctite and attached to the wall with 5 bolts

My civic EJ8 doesn't have space for a 2din radio. In the original radio space i have three 52mm gauges. Previously i had a 1 din radio in the lower tray, but i wanted a 2 din android stereo without removing or moving the three gauges. Is a 7 inch cheap stereo from Aliexpress. So i made a bracket that holds where the cigarrette lighter and ashtray was originally. When the car is parked and the radio is off you can't see it from the exterior.

I don't like how deep normally the emblems are in this tipe of grills, so i made an spacer for them