Search models, users, collections, and posts

Bio
I'm new to 3d printing but have a lot of experience with architectural both 2 and 3d. Based in Ireland
I only printed the 'Toxic' version and sized it up to suit (150%). The infill pattern was a little concerning as it printed, it seemed like it was going to fail, but in fairness it didn't at all and came out great. I had to recolour it to suit so did that through layer height which was a bit difficult to dial in the correct layer but after a few tries it previewed fine and printed great. Very happy with it.
Share
0
0
0
No more data