printed it in elegoo petg pro grey. it turned out decent. small stringing, but no problems. next i printed the white one, the petg has had some issues, but it turned out mostly ok.

looks good. printed with my elegoo petg pro grey

turned out great.

looks great printed in elegoo petg pro grey, had some minor issues though. shown in images. if any1 know the reason, please let me know

seems good

printed great in elegoo petg pro grey.

printed out well in elegoo petg pro grey.

printed nicely with my elegoo petg pro grey

seems great

printed well considering my white petg filament had had some issues.

printed great with my elegoo petg pro grey, it switched spools, since one ran out but it still looks great.

printed nicely with my elegoo petg pro grey.

printed wonderfully with my elegoo petg pro grey.

printed great. i have some layer lines, will have to look into that. printed with elegoo petg pro grey. minimal stringing.

works great. easy print with my elegoo petg pro grey

minor stringing but thats my pla. some Lumps/impr erfections on the blade but nothing big of note. made with spectrum traffic white pla.

printed fine with elegoo petg pro grey. no issues.

printed well on ludicrous mode with my elegoo petg pro grey, though it was too small for some of my cabs but the biltema ones fit. i will keep expanding my skadis wall and fit more on there.

turned out great on ludicrous mode. in grey elegoo petg pro. Nice and snug fit, things to note: did not fit my spectrum pla (traffic white plastic spool) due to diameter being different, however it fit into my elegoo petg cardboard roll, so i'm using it in that for the time being. will make more of these as they seem very useful. the fit was pretty tight, i have to use some pliers to get the lid off each time, could be due to the ludicrous mode maybe? either way though, not an issue really. it's kinda nice knowing it won't pop off during a print inside the ams 2. i put in some really small silica beads that i got with a filament, seems to hold them just well enough to not fall out, i was a bit worried about that, but seems like the hole are just tight enough for it not to happen. minor stringing on the inside, but that's probably due to my speed setting.

made it in grey and white petg. noticed there are some small gaps. not sure if it's an extrusion issue or temp issue or something else.