Awesome design! Please make more like this! Printed on Bambu P2S with PLA matte.

Thank you for this design. Love how this turned out. Used PETG, so I find it a little tougher to rotate. Printed on Bambu P2S with white PETG.

Great design thanks for this! Little tight and not as flexible with PETG. Printed on Bambu P2S with PETG white.

really nice clean print, but still found it popped off the bed on the final layer a couple of times. The hollow bottom with only wall loops might be not enough for solid adhesion. Closed bottom would be stronger. printed on Bambu P2S with Black PLA basic.

Awesome print. The level of detail is amazing. printed on P2S with Bambu matte pla

Great print! Changed the dimensions to what we wanted and turned out great! Printed on P2S with Esun PETG.

Fun toy, print is great design. Hard to open with the tabs a bit still. Printed on P2S with Esun PLA+ for the egg and Bambu PLA for the dino. Scaled the model to 150%.

Love it, no issues with V2 print. Printed on P2S with Bambu PLA.

Fits perfectly, this is awesome

Thank you for this! Just saved my work suspenders.

Thank you for this, maybe Christmas boot prints soo much easier!

Awesome print love this. Unfortunately could only fit 4 spools so bins must have shrunk. Also noticed 1/2" PVC was drastically too small measuring at 16.2mm and 3/4" PVC measuring at 22.2mm fit with some force. I check two stores. I am in Canada so perhaps the pipe diameter here is slightly different.

Great design, the print turned out great! Very clean edges and lines. Now to hang and and see how it performs. You should think of adding a higher front edge or hook to prevent kids from pulling the bar off but the recess for the bushings probably will handle that. printed on P2S with Overture PETG.

Great print turned out very nice. The hide screw tool was a little hard to thread but figure I could turn the bow at the same time which made it easier. Another wall might be nice too. Printed on P2S with Bambu PLA basic.

Great print. Printed on Bambu P2S with .4 hotend, detail is impressive. Would love to see detail with a .2 hotend. Bambu Matte PLA for both colors.

Great print, the level of fine detail on this is amazing! Highly would recommend these. Printed on P2S with Bambu PLA Matte Tan & Grey filament. The grey looks extremely good in the light. can barely see the layers.