Careful, When I sliced this for may P2S it build a tree very tightly around and in the bottom ring. So the ring broke off in the middle when trying to remove the tree supports. I ended up breaking off the rest of the ring and drilling a small whole I then looped a keyring through. Kid was excited it now had some articulation to it so it ended up OK in the end.

Super cute and super clean. The tree left an off texture on the bottom of the nose/mouth. My texture plate almost make it look like snow with the white. Kids loved it.

Turned out great! Printed three at a time. As with other AMS prints there was a lot of poop-waste. I had it slice flat (original) vertical with tree (thinking less changes), but adding the tree supports had even more waste. So the way it is as default appears to be the most efficient.