Search models, users, collections, and posts
Bio
We are a married couple of nerds.
Achievements
Stellar Reviewer
Rate or Comment 228 different models
Pioneer Maker
Print successful 213 different models and 1,526 hours
MakerWorld Guardian
This badge has expired
No issues, printed great even in silk!
Share
0
0
0
I have an old ikea cart and this was the size needed, thanks for doing it!
Share
0
0
0
perfect for my markers that were in between sizes!
Share
0
0
0
Absolutely turned out great, it now is a bedside jewellery box it was loved so much! Thanks!
Share
0
0
0
works very well, exactly what I needed and measurement was perfect! I would use petg as our PLA ones split at the top corner after a month.
Share
0
0
0
really turned out good. Printed with no issues. Use the loose because I was using silk and it worked out great. Thank you very much!
Share
0
0
0
turned out really well, great print, no issues at all and looks wonderful thanks so much
Share
0
0
0
very pleased with the outcome the print is fine I don’t see any layer lines really love the rendition. I got to use my new paint markers so I was really happy. Thanks so much!
Share
0
0
0
As someone else said, the support type was very hard to get off. I eventually got the hang of it but lost two skadis hooks also. That said there are so many hooks it made no difference and it worked perfect for my 14.5mm mrkers.
Share
0
0
0
Share
0
0
0
it printed with that issue but I guess I didn’t pay attention because it doesn’t fit my cart it’s much too small. In width. That said it came out nice.
Share
0
0
0
Excellent, exactly what I need for me filament inventory system!
Share
0
0
0
As many others have said, this is the best model! The fact it goes together with no screws etc. we printed three and had a great time putting them together at the same time!
Share
0
0
0
Share
0
0
0
Share
0
0
0
Wonderful, printed with no issue came out looking really good. Like other people said, lots of poop! But, well worth it!
Share
0
0
0
I’m not sure why but if I tried to make the candy cane all white, then it printed separate, if I tried to do more than one copy of the candy cane it did the same thing. It had a lot of poop in red and white, but that said I finished four of them and everyone loves playing with them, so it was worth it.
Share
0
0
0
The you tube video was great, it printed with no issues and works with no issues! Thanks so much!
Share
0
0
0
Wonderfully fun, had no issues with print or separation on p1s with bambu filaments. used the fuzzy profile.
Share
0
0
0
great model, so cute, thanks so much! I printed a third colour ornament and added a few more :)
Share
0
0
0