only model I found that works great. Fast and clean print. Thank you for sharing your design!

works great but every the filament every plate has to be glued in

works great. Very smart installation! Makes a huuuge difference

Beautiful looking case. No problems at all priming this

Very nice print but I recommend to print it out of ABS or any other stiffer material. The PLA tip is too quickly bent when applying a little bit too much pressure

Im printing with a 0.2mm nozzle PLA Metal and PLA Silk+ onto a 3d effect sheet. It is quiete tricky to get the print right. I wanted to print face down, so the build plate must be 1000% clean. For anyone who has the same idea but gets bad print quality - those settings worked for me (P2S): -Nozzle 230 degrees -Bed 55 degrees -No cooling from the aux fan at all (VERY IMPORTANT! Otherwise the finish will be ugly -Open front door -decreased first layer speed -outer/inner walls -Flow rate 0,98 -> 1 Every other setting just lead to a clogged nozzle. (so far I had to unclog it four times lol).