So far, this is my favorite can opener. I did put a small negative cylinder in the opening to allow the opener to allow the opener to surround the tab a bit more. But still, folks need to push "into" the tab while opening rather than only "up" when using. Works great done that way! Thanks for a great model.

Such a great print! Hey folks, don't forget to push "INTO" the tab, not just up to open a can. That will keep the tab from bending in the middle.

Very nice part, came out perfect. I almost took away one star, as to me this needs a little more engineering love. An updated gear ratio to give more speed to the prop would be awesome, and a tad more space between the pull and your forefinger would making pulling it at speed less or a worry that I'll cut my finger.

Brings your squirt to a whole new level... :)

Printed and worked perfectly!

Such a neat idea, but didn't work well in the end. Turns out Ziplock bags are not that great anymore. Trying to keep the water in the bag is the problem. They burst so easily, that this otherwise great idea just doesn't live up to it's potential. Oh well.

I can't seem to print enough of these, everyone seems to want one.

So much better than other similar models that only plug up vent holes, and eventually fall out of them.

I was difficult waiting for my printer to squeeze this one out...

This print grabbed my attention, as well as a few chips.

This print turned me...

Printed easy, and sounds great!

Turns out very pretty. I don't think the 45 degree angle in printing did anything for it though. It came out a bit rougher than expected, had to clean up a little, and some joints were rough and took a bit longer than expected to get loose. The logo on the edge kind of took away the aesthetics. Also, it would be much nicer if it was heavier, so I may reprint with a lot more infill. Overall, it has potential.

Very fun, just took forever to print. Keep up the great work!

It's OK, but too small for all my accessories I have for my TS101. Needs a lot more storage space.

Perfect for what I needed.

Nice print, but too much fidget for me...

Would love it more with a solid side on both sides in a print in place model.

I remixed this a bit to provide deeper table edge bite. Now it fits on my rounded edge tables better. Also put a thin rubber sticker under the top to help it grab.

My wife said I have hangups. Now I can agree with her! :) Great design. Much better than the gravity ball versions.