Such a beautiful tree! I did mine in silk pla filament except the dirt it’s regular pla, and I love it! I did find I had trouble with one of the foliage though. It needed the wholes to be a tiny bit bigger, the one at the bottom right. I just used an exacto knife. I think all the wholes could be made more easily visible/deeper so they stay on the tree better. Some glue would do the trick too but deeper wholes would be something I’d prefer. Other then that, a great bonsai tree!! Go print you one!!

Geat print! Great for little X-mas gifts! 🎁

These earrings are so cute!! 👌🏽👌🏽 Great X-mas gifts! 🎁

Great print! The grinches face could be better, but my daughter picked this for our Xmas count down. 👌🏽We did switch out the blocks. All in all, good print!

These panels for this beautiful lantern are BEAUTIFUL! 😍 Thank You!! 👌🏽👌🏽

This lantern is absolutely BEAUTIFUL!! 😍 Amazingly GREAT PRINT! I didn’t print the panels, I chose different panels. But the lantern itself… FLAWLESS! 👌🏽😍👌🏽😍👌🏽

Flawless print! Love it!

Beautiful print! Love it! 👌🏽

BEAUTIFUL PRINT! 😍 I love it! Doesn’t take to long JUST under 3 hours. I have made two now and both are perfect! I will be making more for sure! 👌🏽

Turned out Beautiful! It did have these lines on the top side of every piece, I dunno if it’s the seams!? So I ended up using the side that was face down on the plate, which turned out fine, it’s shiny so works with the silk filament. I also sized it up to as big as possible. 👌🏽

They came out great! 👍🏽I have it on a keychain ring and hooked on my work ID keycard. It gets dropped and banged around at work and is holding up beautifully! 👌🏽So far the quality is wonderfully strong. 💪🏽 The pink is a regular PLA and the purple is a Silk PLA.

It’s Beautiful! A flawless print. Amazing job on this file! 😍I used a Brown PLA-wood filament. 👌🏽👌🏽 Perfection!

Came out great! I wore them to my brothers wedding and everyone was amazed that they were 3D printed! 😍

Worked great! So impressed. To note, the middle piece I didn’t know but now I do, next time when doing a rainbow filament the middle piece needed to be printed flipped upside down from what the file has it so when it’s all attached the right colors line up, you can see in the photo. Nice print though. 👌🏽

It’s BEAUTIFUL! I sized it up to the size of the plate. Love it! 😍

It’s ABSOLUTELY BEAUTIFUL! STUNNING! So impressed! I sized it a little bit bigger. Next time I’d make it thinker too, I prefer it not so paper thin, I wanna print a stand for it. But other then the minor things I’d change… AMAZINGLY BEAUTIFUL PICTURE! LOVE IT! 😍😍😍😍😍 Filaments I used: Bambu Basic PLA - Black, Grey, Brown , Beige .

Beautiful design, thank you! We 3D printed the bearings too, instead of buying some. Worked great!! My daughter doesn’t have circle nail polish bottles but still works!

It’s BEAUTIFUL!! Great print! Next time I may resize it to be bigger though.

My daughter wanted this Walrus statue. She loves it. Looks great. We did have a little issue taking the supports off, it was on there good and a tooth cracked but we just glued it.