Another awesome model! This is the second antler model I've printed from DTM247's collection. Scaled at 80% it printed perfectly, and like the first model I printed, the supports came of clean. The skull printed with the set is the Fractured Lighting version. I've already started printing on a 3rd model. Thanks for sharing!

Awesome model! I printed this at 70% and it turned out amazing. Supports are easily removed. I plan on priming and staining, and will definitely be printing more of these models by DTM247.

What an awesome model! Took close to 29 hours to print on the H2C, but was well worth it. I've printed two of these for two of my grandsons 2026 Christmas presents. Printed in BL Matte Charcoal, BL Matte Bone White, and BL Matte Dark Chocolate.

Printed out nicely! My wife did the painting.

Very nice chess board, which printed without issue. Printed with TECBEARS Wood PLA (Walnut), Giantarm Silk (Gold), and BL Silk+ (Silver) on the H2C. I designed and printed a storage box that holds the board quarter panels, and the chess pieces (Stylized Chess Set by 29FLO). Will be a birthday gift to my grandson.

Nice chess set! Printed out nicely except for the knights, which I had to print a few more time to get a successful print. Outside of that everything else printed on the first try on the H2C. In addition I printed out the modular chess board, and a case that I designed, that stores everything. Will be a nice Birthday present for my grandson. The chess pieces were finished with Gold and Silver Leaf Rub n Buff.

What an awesome design! Printed flawlessly with TECBEARS PLA Matte Oak on the H2C. The wife loved it so much she found room in the house for it next to our bar. Will probably print as gifts for my son and soon to be son-in-law.

Another awesome model! Scaled this on up to 850% and printed on the H2C. It printed perfectly, and my wife loves it on the fireplace mantle next to the Christmas Santa print.

Awesome model! Printed out great, and the supports were easy to remove. After printing the initial model my wife want me to print some to go with a dining table arrangement for Christmas. Scaled the model up 250% and painted the scarf and leg bands in the slicer. Printed on an H2C.

Awesome design, especially when you consider the tolerances required to fit the top of the H-Series printers, and still be able to remove the glass top. I printed mine for the H2C with PolyMaker ASA (Jet Black and Grey). Other than performing the calibration runs for the specific filament, printing a shrinkage test, verifying, and incorporating the shrinkage factor to the filament, this was the first project printed on the printer. The very top layer of the two halves that have the accessory mounting slots were a little rough, not sure why. So I designed a swatch card holder strip (using the swatch card holder developed by Mark’sMakerSpace) that mounts to the accessory slots in the front, covering up the rough surface edge. Again, thanks for sharing such an awesome design.

Printed out great. Thanks for sharing!

Print turned out great! Thanks for sharing!

Another perfect print from this designer. Thanks for sharing!

Another perfect print profile from the designer! Thanks for sharing.

Printed out nicely! Thanks for sharing!

Printed great! Thanks for sharing.

An awesome print!

Printed perfectly!

Turned out awesome! Just waiting on some resin to seal the inside. Will probably end up printing another.

Awesome print. Now I have a place to organize all my pens laying around on the counter tops...yah right.