This model is fantastic!!!! Thankyou so much for making this it is exactly what I needed!!! deserves 10 stars!!!! I will boost when I get a boost token!!! the only improvement could be to make the edges of the watch strap and strap holders rounded not square, it would make it a little more comfier as the edges wouldnt press into your skin. otherwise it is such a good model thanks again I love it. It is replacing the original strap that came with the watch because after many years of use it is litterealy falling apart to the point of dysfunction. lucky this 3d pri table strap saved the day and I don't even need to spend money to buy a new one!! thanks again!!

This is a cool print. I needed to cut some of the inside rail off on both side walls to make it not get stick and it works great. Later I decided to cut a little bit more off but this was a mistake because it slides too easy now so it basicaly solves itself by just turning the dial. this could be amended by making the user have to slide the lid up instead of down. I also sprayed the lid mechanism with silicone spray which made it spin perfectly smooth whereas before it was quite hard to turn. the bottom of the disk on the lid also gets caught on the side wall when opening. overall this is a cool and stylish print but really easy to solve.

simple, good, it works

This is a great model. I printed the 7 card with money drawer in black petg. It did not get 5 stars because the card pusher is a little bit too skinny so sometimes a card can get stuck between the drawer and the card pusher and you need to poke a card in the gap from the bottom to free it. The card pusher needs to be wider and often card dispensing is uneven. also the cutout/slot in the money drawer is also too big and 5c coins fall out and 10c & $2 coins fit through. some improvements could be added but otherwise it is a great model which is why I boosted. Edit: added 2 pictures. I printed the caliper card by @martonlengyel.design and it takes up the thickness of three normal cards. I slightly sanded the corner of the lip of the folding edge on the card to make it fit and the card ejector still works good. actualy most times it works better than when full of normal cards.