Search models, users, collections, and posts
WATER GRENADE
IP Report
Print Profile(1)
Easy Fast Print, Pre-Supported 0.2mm height
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
4202
7801
310
60
3 k
1.9 k
Released
Description
Pull the pin and throw them fast, they will explode!!
Transform your Water Balloons in Water Grenades
Share your prints!!
INSTRUCTIONS:
Intoduce the tip of the balloon and clip it in, then secure it with the pin.
You can use a spring from any kind of pen to make the latch fly off when thrown and to ensure the balloon is released.
Follow me on:
Instagram: https://www.instagram.com/afo3d/
TikTok: https://www.tiktok.com/@afo3d
Youtube: https://www.youtube.com/@AFO3D
Licensing
All my designs are non-commercial and may not be sold, reproduced, or shared outside of this website.
If you wish to sell any of them you must subscribe to my Thangs.com or Printables.com Commercial membership plans.
Reccomended Print Settings:
- Support
- Brim
- 0.2mm layer height
-AFO
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (310)