375% egg
Print Profile(1)
Description
I wanted it big, so I made it 375% bigger. The threads are still a pain however I made 13 of these and they all worked with some trimming. You simply tapper the beginning and end of the thread on the lower section so when it locks in you can take it apart. unless you want it almost permanent to play a trick on someone. If the egg was tight for the little kids, I did slightly sand the threads with a green pad and apply a bit of wd40. After running the egg open and closed 2-3 times it started to break in and become user friendly to most everyone. You also may notice that the lower egg is 1% or so smaller. This was because I didn't want to change my printer's calibrations for a bad file. I was also not wanting to design this from scratch as I had a week to print out 13 of these.
This remix is based on
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including, but not limited to, publishing derivative works outside the Makerworld platform or hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money or collect fees. Subject to the above restrictions, derivative works may be published only within the Makerworld platform, and all such derivative works must be licensed under the same SDFL‑C license, without modification or additional terms. You may download the digital versions of this object, 3D print it, and display images, videos, or usage demonstrations of 3D printed versions of the object on personal social media platforms or Makerworld official channels, provided that no digital versions of the object are shared or distributed.
Comment & Rating (0)