Search models, users, collections, and posts
Backpack Hook
IP Report
Print Profile(4)
Heavy Duty 1pc
Designer
1.2 h
2 plates
Heavy Duty With TPU Non-Skid Pad
Designer
1.6 h
3 plates
Backpack-Hook-TPU-Hinged-Med-Duty
Designer
2.3 h
3 plates
Backpack-Hook-TPU-Hinged-Light-Duty
Designer
1.8 h
3 plates
Open in Bambu Studio
Boost
24
97
4
2
52
32
Released
Description
I have this hook permanently attached to my backpacks. Use it when I absolute don't want my bag to touch the floor when traveling. It can be hooked to the edge of a countertop or coat rod (up to 32mm thick / diameter) or a belt loop of my jeans if not too heavy.
There are 2 sizes - one for 1" and the other for ¾" web straps. Uses less than 15g of filament. Print in PETG since it holds up better under loads.
Please give me a boost if you found this useful and post comments about the good, bad and ugly.
Thank!
Added print profile with TPU non-skid pad to keep it from sliding off counter top and hook gap increased to 37mm. 02/06/26
- Added two hinged version - medium and light duty. Conservative working load for light duty is 2kg and 4kg for medium duty. Original 1pc versions has been tested with 8kg plus loads. 02/16/26
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (4)