Search models, users, collections, and posts
Rv Stove Knobs V3
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 6 walls, 10% infill
Designer
4.5 h
3 plates
Open in Bambu Studio
Boost
0
3
0
0
2
2
Released
Description
This is a remix of the original knob I published, https://makerworld.com/en/models/1955210-rv-stove-knob#profileId-2101278
This version has the position markings configured as a modifier so you can change the colors to suit your needs. This was printed with Black and White PLA. No supports are required. Print face down. I used 6 wall loops to increase the strength of the shaft. These knobs have been in use daily for over a month without any issues.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)