3D Printer Emission Sensor Array (Sensorbox v2)

I have used the two linked code bases to add some features to it as well as updated the model to hide the red bezel of the screen.

The code changes include the following:

• Wifi Icon in the top left. (Red if disconnected, green if connected) (only page 1)
• Time and date in the bottom right [DD/MM/YYY] (NTP enabled), autohides when Wifi is disabled to not have an error show. (only page 1)
• Added a text popup when turning on/off wifi to see if it actually did it. Same for saving the SGP30 Value baseline for reboots (no re-calibration needed)
• Added different brightness modes. 100%, 33%, 15%, OFF. Sensorbox defaults to 33% (bright enough)
• Edited button logic. Short/Single press = brightness, medium press = switching pages, long press = toggling wifi, very long press = manually saving the SGP30 value baseline with text popup IF the current values are in the safe threshold to not skew the baseline.
• Rearranged  the 2nd and 3rd page and swapped Pressure with Particles.
• Added an automatic save of the SGP30 Baseline every couple of hours that gets restored on reboot.

Button cycles:

Brightness = 1ms - 490ms
Switching pages = 500ms - 2000ms
Wifi toggle = 2200ms - 5000ms
Saving baseline = 5100ms - 7500ms