LED Display Box

I designed this display box for my wife's UV reactive rocks and crystals. I installed a UV LED strip in the top and it has a little hidey corner in the back to run the wires out of the bottom corner. Alternatively, you could install any LED strips and use it to display anything that would fit (internal dimensions are 127mm w X 127 mm d X  117 mm h). I have only had my printer for about a week and I am very new CAD and printing, so I'm quite proud of this little project.

I'm currently using a USB-to-bare-wire connector with a built in 5v to 12v up-converter to power the LEDs. I feed the bare-wire end up through the hole in the back and then solder to the LEDs. Along with some cosmetic improvements, I also plan to make a version with a large enough corner/hole to be able to feed a USB connector through without needing to solder. When I get that worked out and uploaded, you should be able to any USB LED strips, so check back for updates if that's your plan.

The mushrooms in the picture are a remix by danshti of the Dual Colour Modular Mushroom Caps by DaveMakesStuff from Thingiverse and they can be found here - Glow in the dark mushroom diorama.