Search models, users, collections, and posts
casetta raspberry
IP Report
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
2.6 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
5
20
1
1
20
12
Released
Description
Content has been automatically translated.
Raspberry case with three variants
1. with fans to improve temperature
2. without fans, standard case
3. possibility of hanging it on the wall and side grilles
To install the Raspberry, 4 M2.5x4x3.2 threaded inserts are needed.
For the lid, 10 magnets of 6x1.7 are needed.
Finally, if you decide to print the model with additional fans, 2 25mm fans for Raspberry Pi are needed, easily available on various sites like Amazon, Aliexpress.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)