Search models, users, collections, and posts
Sponge Holder
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
4.5 h
1 plate
Open in Bambu Studio
Boost
4
3
2
0
6
2
Released
Description
Looked around for a sponge holder that would work on my kitchen sink and did not have much luck. I finally found one but the amount of filament it used was outrageous. So, I designed my own. I printed it in Sunlu PETG Silver. I did not need to add supports and it came out flawlessly. Works great with the Sponge Buddy pads.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)