Search models, users, collections, and posts
NES Controller box top (FLUSH)
Remixed by
IP Report
Print Profile(1)
Single AMS, Colored, Slowed 1st layer, Reduced 1st layer width
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
23
45
10
1
28
15
Released
Description
Remixed the Nintendo slide top to print face down making the model flush and allowing it to be printed completely support free. Model is setup for a single AMS
Get the bottom half of the box from the original creator at: https://makerworld.com/en/models/158784#profileId-174295
Recommended:
- .16mm layer height
- .32mm first layer width
- White/Light Grey , Dark Grey, Black, Red
If first layer adhesion is a problem, try slowing down the first layer speed or running the first layer in “silent" mode. If all else fails you can always use hairspray, small text is not always easy to print.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
GIF
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (10)