Whimsical Easter Egg Tree

A cute and whimsical egg tree. It makes a perfect decoration for Easter time. All parts are printed separately and connected together afterwards. You can store some small trinkets or candy in the cracked egg under the tree.

• No Supports Needed.
• No AMS Needed.

• No Glue is necessary, unless you think things are loose.

  Note: The tree does sit loosely on top of the cracked egg.

Make sure your print plate is clean. The tree branches are tall and skinny and might fall over during printing if the plate adhesion is poor. Leave the auto generated brim on to help hold the tree branches on the print plate better.

Assembly Instruction Video:

If the above video doesn't work, here are the steps:

• With the grass seam to the left, the tree branch with the shorter branch goes to the right-side hole. Tallest branch goes in the middle (put the middle branch in last though). You have to push and twist a bit to get the tree branches in to the grass. The branch orders should match the picture below with the grass seam to the left. 

  

• Push and twist to get the eggs onto the smaller tree branches. Both big and small eggs can fit on any branch.
• Note: The tree will sit loosely on top of the cracked egg.