Elf-Bubble-Bar

Your colleagues take a smoke break every 30 minutes, but you have to keep working because you're a non-smoker? I have the perfect solution for you: Elf-Bubble-Bar!

• Remove the inside of a used Elfbar: 
  • The mouthpiece can be removed with a simple bending motion
  • The lower part is more difficult to remove, you have to pry it open with a sharp object (e.g. scissors) 
• You only need the metal sleeve and the mouthpiece. Dispose of the rest (please recycle the battery)
• Rinse both parts
• Put the mouthpiece back in place and put your print on the other side 
• Your Elf-Bubble-Bar is ready!

Print:
The dimensions are very precise. As the first layer is pressed onto the printing plate, there is an elephant foot effect where the first layer expands slightly. Therefore, activate the elephant foot compensation to 0.15mm. Otherwise the model will not fit into the sleeve and you will have to sand down the edges.

Soap bubble liquor:
You can make your own by mixing water, dish soap and sugar.

Have fun!