These printed great. You just have to be careful when removing the inner supports and not to over bend the tail. I’m very happy with these prints and will make more.

These came out great super cute! Printed well

The under the ears and mouth portions didn’t print very well like they lost the curved look as the rest of the piece.

Printed great,everything fits perfectly! I’ll probably be making more of these.

Printed fine, just not a great spin on these for that amount of material U expected better performance than thinner ones I’ve printed with better spin quality.

So awesome, this was the first clicker that I’ve made. and it came out great!

These were great to make! I love making these and found that if you print in translucent tea lights look great in them too! I did have a tough time with the lid and sliding filament in and cutting it. I guess mine was pretty thick but, I still managed it and it came out great!

Printed very nice. I took one side off of this when I printed it so it could be flush against another object. It worked out well for me.

This is Beautiful!! Came out so awesome! I made this as a gift for someone. I’m looking forward to them being surprised by it!

Pretty cool looking duck. Supports were not the easiest coming off. for some reason supports left a mark on the back of the cape. In my opinion he did require a little cleaning up of rough edges in a few places (beak,teeth,cape). I used an xacto knife that’s a bit dull for this. I really do like the model otherwise and think an ams option would be awesome for him! I may try to paint him. I made him in multiples for cruise ducking. 😊

These are so beautiful!! Lovely Designs! Printed great!

Print came out really well. I thought this was a fun thing to print. I did a little work on cleaning up a few small rough areas from supports mostly and I think he looks great!

Broken lines in the image after printing.

I made this a bigger keychain instead of earrings. I did wish there was a separate colored tongue piece to glue into the raised areas that the area underneath there was colored with ams. Nice print!

Came out great! I like the raised areas on this print,

I picked these because I liked the look of them. They looked very sturdy. They printed nicely and have a nice weight to them. I like the caps. however my 1inch dowels had to be sanded down to fit into these. especially the center bracket. I had to sand the dowel and the bracket quite a bit. I’m very happy with my shelf though!

Printed pretty good but definitely will see prominent lines in it. I don’t know if adding ironing would help much. I did wish that the feet were like a pop on or twist on. I dropped a plate and one broke off. They are still very cute! if I print any more I’ll try to do some ironing on the face parts.

I love the styling of this container and it printed great, minimal flaws if any. It looks like something you’d buy at Target. It feels hefty like it’s going to hold up well too! I printed mine with overture matte turquoise. and the small one is Bambu basic blue.