Very well done !

prints great ! thank you

came up great and is such an original idea. which the creator disclosed what font is used in the photos but nonetheless this is great. thanks.

absolutely amazing. it prints perfectly as well.

print like factory made. great job !!

Prints perfectly. But design has several minor flaws, it does not cover the screen entirely (tiny little gaps). The lid does not match the base perfectly and comes off easily. Again, minor flaws but my OCD triggers bad. It is fantastic thin, low profile, simple. Thank you.

prints perfectly. the other profile that says it has had supports and impossible to remove is not true at all. This solutions is very clever and convenient. The only thing I wished is that provided clear instructions ie assemble, what bolts to use, etc. Thank you !

prints great. at the end was not a good solution for me because it’s flexibility. but they came up amazingly well and helped me find my ultimate solution. great work ! thanks.

Giving 5 stars for printability. It prints without issues. however is not amazing, I’ve printed other racks that offer better assembly instructions (not guessing) and structurally stronger. is a good option if looking for filament saving.

prints and works like a charm ! thank you. leveraging your project, created my own solution for another problem 😊 https://makerworld.com/models/2614527?appSharePlatform=copy

prints perfectly and looks amazing

great

great

perfect

prints welll but unfortunately does not work. it heats very uneven and reduces the dryer power considerably

prints great

supports are very hard to remove and leave marks behind.

supports leave behind ugly marks but everything else prints very well and is a great solution 👍

Prints perfectly with no issues at all. I used PETG HF. While operating the stack ie pulling out the bottom ams or lifting the upper ams, the AMS (both) slightly comes off the back of the seating frame. Does this happens to anyone else or did I do something wrong? wonder if someone has come up with a clip to secure the ams from the back to the frame. Also the clips with magnets to keep the lid open were a real pain. Some tolerance is needed for the magnets to fit in. At the end had to use heat to push them in place and glue. Sadly the bolt that holds them in place is too stiff and they are really hard to operate, the magnets do nothing in fact.