I wanted a tensegrity that wasn't just cool but USEFUL. After several prototypes I found a way to make a real cup "float." The hardest part? Balancing tension and weight without losing the wow effect. I chose hands and heart to give it soul, but the top is fully customizable — just start from the 120mm base. Here's my challenge: design your own top, print it and show it here! Feel free to upload it as a profile on the project. Who makes the most creative one? 🎨#Contests #Cupholder(Edited)

#Newmodel A fully 3D-printed airbrush paint booth solving bad lighting, scattered tools, and fumes at once. USB-powered COB LED bars with diffusers for shadow-free light. 100mm fan port with replaceable kitchen hood filter. Skådis pegboards on both sides for brushes, paints, and mixing cups. Filter box lifts off, filter mask snaps out for quick swaps. Small bed variant included. Full PDF assembly manual in 10 phases with real photos.

After months of iterating, my modular airbrush paint booth is finally live. The problem was simple: painting indoors with an airbrush means bad lighting, scattered tools, and fumes everywhere. Commercial spray booths are either too small, poorly lit, or cost 150€+ for a plastic box with a fan. So I designed one from scratch in Rhino and printed it on a Bambu P2S. What's inside: - 3 COB LED bars (5V, USB power bank) with printed diffusers for even, shadow-free light - 100mm fan port with replaceable kitchen hood filter for fume extraction - Two Skådis-compatible pegboards on the sides for brushes, paints, airbrush holder, mixing cups- Full assembly manual (PDF) included with step-by-step photos and wiring diagram Everything is glued with CA except the pegboards (8x M5 screws). The roof lifts off for maintenance. The filter mask is removable for quick filter swaps. I also included a small bed variant with split plates for printers with smaller build surfaces. This is the biggest project I've published so far — feedback, questions, and remixes are all welcome. #Newmodel #Sharing Tips #Creator's Club