Was concerned when I couldn't get it to spin after printing. Grabbed it with some pliers and with very little effort the model started to spin. Great gift for a co-worker who loves rotary.

Printed great. Wheels spin smoothly. Works great with Duplo blocks.

Printed great. Will need to try and print in a stronger filament. After a short time, the PLA wore down and the bucket no longer stays in position when lifted.

Required a good bit of post processing for G45. Surface finish was spectacular.

Great design and fits perfect in the containers. No issue with the print and holding low teens with dried filament. To re-roll after changing colors, just open the pouring lid and use your index fingers to roll the filament back on the roll. No need to open the entire box. Doesn't seem to affect humidity levels in the box at all as the desiccant soaks it up. Recommend quality bearings as I originally purchased the cheapest ones and the rolling resistance is pretty poor. They work but feel like smoother rolling would be easier on the machine.

Perfect fit.

Not the prints fault but a warning to others, do not dry your filament with the clips on. It will weaken their retention. Should've been obvious but I'm still new to this and wanted to share what I learned here. Great clip that can stay on the roll while printing as long as it's on the exterior side of the roll when mounted in the printer. Using a single roll, not ams..

Printed a large and regular box, with a combination of boxes to fit both. Just need to print the storage now. Smooth assembly. Rather than using screws for assembly, I had a bunch of brass rods in various sizes and glued them in place for the hinges and latch. Works great.

Overall does what it needs to. I understand it was printed but was expecting a little more air flow. As others have said, careful when tightening the screws.

Print and assembly was great. As others have mentioned be sure to install the handle bars before gluing together. Also want to mention to be sure they are oriented correctly if you glue them in place like I did. Only thing I would change if I print again would be the orientation of the handle bar grips. I would print them at a slight angle to change the layering. Bike took a tumble and one broke. Might require more post processing work but would likely hold up better to a smaller child.

Does what it should. Printed great.

Printed great. Assembly was smooth.

Son loved it! Rollers were a little stiff but eventually broke it and roll on their own. Roller supports were a pain on the first one but taking a pocket knife and slicing perpendicular to the support made them come out super easy with a metal pick. Ended up printing a second one!

Printed for a gym friend. Was worried about the eyelet breaking putting it on a keyring but had no issues!

Back for the second time to grab the power-up kit. Needed the slightest amount of post processing work but overall very satisfied.