Search models, users, collections, and posts
Bed Rail Base Cover
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
20 min
1 plate
0.2mm layer, 2 walls, 15% infill
20 min
1 plate
Open in Bambu Studio
Boost
145
324
123
15
706
435
Released
Description
Plug/Cover to block debris from getting inside the hole at the bottom of the rail for the bed.
Was just looking to grab a hair more clearance so I trimmed 1.25mm off the top of the model to make it slightly thinner (2mm vs 0.75mm, you can see the difference in the second picture). Credit to clselee.tw for the great model!
*Note: When the bed is fully in the bottom position the bearings on the rails slide in to these holes, so just make mental note to remove them if you plan to print with the full range of the Z axis
Boost Me (for free)
Found it helpful? Send me a boost, thank you!
Looking for more covers to clean things up, check out some of my others!
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (123)