Eiffel Tower

This is not my model — it was originally created by 3DDesigner on Thangs:
https://thangs.com/designer/3DDesigner/3d-model/Eiffel%20Tower%203D%20Printable%20model%20-36495 I’m sharing it here on MakerWorld so more people can print it easily. Make sure your print bed is clean and use good bed adhesion — there’s not much surface area for it to stick to. I used glue, which helped a lot.Tip:
Avoid scaling it down, since the small railings can become too thin and cause the print to fail.