Search models, users, collections, and posts
8BitDo Ultimate 2C Wireless Controller Stand
Remixed by
IP Report
Print Profile(2)
0.16mm layer, 3 walls, 15% infill
Designer
1.6 h
1 plate
Horizontal printing, 0.28mm layer, 3 walls, 15% infill
56 min
1 plate
Open in Bambu Studio
Boost
27
70
21
1
215
128
Released
Description
An excellent stand or holder for the 8BitDo Ultimate 2C Wireless controller!!
Compared to the original model by Mr.TiePie my version offers the following improvements;
- 54% Lesser Material Use
- 50% Smaller Footprint (ish)
- 63% Quicker Printing Time
This model is a stripped down version of it's original (after deleting the wire spool), using the same settings (except infill from 15 to 12%).
The controller sits firmly in the stand, thanks to Mr.TiePie for the nice fitment!!
Please visit his original model for wired version controllers.
Thanks for Printing!!
/CylinderSwede
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (21)