awesome product, works exactly like I wanted it to. don't be tempted to down scale it to a thinner model. if it's any thinner the waters surface tension holds it under the tray. so leave it at the 10mm or at the very least you need to slice the top down don't scale it down and lose the riser height. but you'll need tk watch sagging which will cause the same problem.. so unless your super into tweakjng this 5 times, I think the OF design is perfect

Print went well, wish the profile had a lower layer height, but not super important. still have to try it on the fan I printed it for

printed well

works awesome, clips on so no fumbling around like V1, I was initially concerned about the gaps but it made no difference at all to performance. A++ for responding to suggestions and loading up a stellar design

absolute A plus job, works exactly how I wanted it to. a little more snap would be nice but but does what I need and it's super simple, love it!

Amazing print profile. I had never done a sequential print before so it kind of sketched me out. But outcome was flawless and love the clean design.

great design. organized my big spice bags

well designed and no real complaints

awesome design, takes some bending to put the slide tab in but these things are really cool

top notch product. great design and love that I can keep my reels the same. a little disappointed that I can’t find the right filament colour though but that’s not the designers fault

awesome design. I put a little grease inside the bearing race and it quiets it down as well as smooths it out

does exactly what it’s supposed to do.

did exactly what I wanted them to do … the amount of support was crazy though haha .. no real way around it I don’t think …

gets the job done. however seemed to have e some difficulty sticking to my mounting tape… I don’t think this has a thing to do with the print profile or a thing but just thought I’d mention i put a little super glue on the hook side of the double sided tape and worked like a charm

sucks that you have to print those extra screws, an updated profile would be nice but overall still a great design!

unreal design, absolutely love it. I struggled with the supports on the arms though. but still think this is a genious design

awesome design, make sure you know how thick your cubicle wall is they vary quite a bit by brand

works perfectly for the 250g sunlu spools

love the design and the multi color offering right out of the box. ponlyntrouble I had was on the downward face of the “wing” I couldn’t get a good finish where the supports where holding up. I’m sure I could have done better but I think after 27 hours I’m not gonna print another set for some small defect. printed 0.16 layer height, Bambu Basic Blue and Bambu Silk Gold.