Printed with white tpu and dyed pink with clothing dye!

Printed with tpu, works great indoors!

used as a test point for some new tpu filament, worked great

Printed as a joke for a friend who seems to love the song.

Works great, the angle ends up just right for getting some leverage. WICKED SHARP!

works as you would expect

was a bit tight for normal bottles. had to scale it up a bit from the original STL

standard benchy, does the job

This should have been designed with something other than truss screws being the main fastener. the 2.6 mm is very difficult to find without having to buy an assortment of 500 screws to get 40 of the size you need.

Printed with PLA + wood, looks super realistic

Printed for a co workers kid, turned out great

Printed for a co worker's kid. They turned out great

I printed this in realistic colors and then sprayed the pot with a rock texture spray paint. I also inlayed some metallic filament colors into the pot rings for a nice bezeled finish!

I printed this in realistic colors, and then used a can of rock texture pray paint to make the pot look great! Great print!

I had one small issue with print lifting, but it was my own fault for not cleaning the print bed well enough. Print worked great!

Printed great, Much louder than I was expecting!

This works great as is, but i eventually redesigned my own to get rid of the half inch gap between the bottom of the cut and the rail