great little stand. printed in PLA. I flipped one side so that the texturedside will match. 

mcfly2015

it_could_explode

Guitar stand - strong, no supports

Books read counter

A1 light bar

XTEink X3 model

Necklace and Earring gift box

I hated having to go back & forth to adjust my airbrush PSI, so i made a quick desk clamp for it. 

Compressor filter desk clamp

perfect print. I printed six of these in PLA and attached them to my car mount. then drove 200 miles with them. great design 

GTPerrault

1 inch (25mm) Strap Keeper

I needed a cleaner for my airbrush, and i refused to buy one. I could not find on that suited my needs. I found one very close, but it didnt fit the nutella jar i had on hand (370g), so i decided to use it as a muse to create one of my own. All you have to do is stuff some paper towel in the empty slot, then put the cover on. Then place the screw ring over it & screw onto the nutella jar! 
While i was at it, i also created one for the 450g nutella jar as well. Hope this helps someone else!


perfect print. I knew there was a reason I kept all those 40mm cases.

bryan.morris

NH35 (28.5mm) print-in-place Dial holder

Earn this badge when visit MakerWorld more than 20 days in last 30days UTC time

MakerWorld Guardian

Earn this badge when rate or comment more than 200 different models

Stellar Reviewer

Earn this badge when print successful more than 100 different models and 500 hours