Used transparent green PETG and black PETG. looks great!

Super cool and great quality print! Barely any waste. I think I’ll scale it up and try again. only issues I faced were some thin and slightly lifted parts from the ironing, but that may have been my fault. Not sure my gray filament was fully dried. Either way thank you so much for this. if you could do the same for sundowning and this place will become your tomb I’d be forever grateful 🥲

Printed great! Looks and feels sturdy. Honestly minimal waste on my P2S. Made it for my friend who is a die hard bolts fan, and he loves it. Thank you so much. I used the cool tack plate just in case of adhesion issues, as I was running low on white PLA I didn’t want to mess it up.

turned out great. quality is awesome. had an issue with the egg catcher channel being tight like described in the profile but a little work and it fit great!

I don’t think I dried the filament enough, and I printed from the handy app so I didn’t have any supports enabled. Oddly enough it still works like this!

Excellent smooth print, in three easy parts. Used glow in the dark yellow PLA.