works like a charm

super helpful, especially with the top mount ams lite

super cute, and came out very well! the supports took a fair bit of scraping to fully remove, but no damage was incurred. the beak consistently printed with a little lopsided point, but snipping it off resulted in it looking perfect!

Very cute and solid! This was a great first print.

Very smooth and convenient! Note that the "A1 two color" version works fine with no collisions on my A1 using the official top mount (https://makerworld.com/en/models/92486-ams-lite-top-mount-for-a1?from=search#profileId-509215). Specifically, the "0.2mm, Less material, faster print, higher strength 0.2mm, Less material, faster print, higher strength" version.

I'm not sure why, but my first print of this had a totally solid bottom (the ring and the hub were fused together smoothly in one layer). I was able to slice them apart, but it deformed the outer ring. Subsequent prints didn't have this problem.

Super cute! My first articulated print. The head squeaked while turning, so I shaved a tiny bit off of the neck nubs to reduce friction. If you do this, don't do to much, or else the head can just fall right off!

Seems like a decent alternative to the official top mount, but at least on my AMS lite, none of the included screws were long enough to secure the printed mount to the AMS itself (I know the screw is optional, but I'd prefer to have it attached). One tip is that plates 1 and 2 fit on a single plate on my A1, so I was able to do them both overnight!

Very useful, and supports came off easily

Very clicky! Louder than I expected, to be honest :P