made the flagpoles longer to use as a cake topper decoration. printed great.

the print was good, but as a design it lacks a few details. This flag is only checkered one side. I noticed this on the slicer before printing, and addressed this by increasing the height only to 500% size, then cutting down again to 3 mm height, which was its original height. Additionally, the flag itself is too big and heavy, for the tiny flagpole that’s not long or thick enough. This flagpole length only works if the flag itself sits on the cake. this can be addressed in the slicer too, but is a lot of work.

etched this on glass. result was great. used 40 watt laser on H2D

Printed at 40% size with a 0.2 nozzle, and worked great still

great design. I used hot tap water to thermaform these.

worked great from first attempt with provided settings!

some parts of the instructions were a bit hard to understand at first, but overall is absolutely amazing and instructions are a very great tool or I would not have been able to put this together right. I did have to adjust the laser settings, as it seemed to have been set for 10 watt laser, not 40 watt. this caused it to cut through paper in spots where it was supposed to just mark it.

prints amazing with set settings. hearts split easy enough afterwards for even pre-teen kids to be able to split them. msgs can be decent big enough size as well to be able to read easily.

this worked great to print, and is easy enough to split afterwards. msgs can still be a decent size aswell.

rearranged and printed 58 at the same time on a H2D unit.

printed really good. therma formed under running hot water from the sink. amazingly even results!

printed great. used tpu filament for the drawbridge wire

printed pretty decent, but design itself is not very flat at the bottom. this could lead to poor bed adhesion.

printed nicely.