Printed fine, but the design would’ve been even better without bands, and you could remove the top without removing the hide from the terrarium. Other than that, my daughter’s snake loves it!

Would have loved if it had been black and white, but I printed it in all black PLA basic, and it looked sooo good. No problem with getting the support off either. My daughter’s BFF loved her gift so so much.

Really nice print. I used it as a gift to present a song for an event (a very Danish tradition for special occasions).

Love this one! I've tried a few different models, and this one is by far my favorite. It even holds the cord while hanging from the socket. Might try scaling it up to see if it'll fit my Macbook cord.

Printed perfectly. Made some (two different color combinations) for my best friend, who's doing breast cancer treatment at the moment. She was so so happy, and put a pin on them. She's wearing them every time she leaves the house.

The danish flag, but with the possibility to chance both colors. This print is 37x28x3 mm.

Top nice print.

Really nice print. I made it a bit (about 3cm) taller though.

Prints perfectly. My husband and daughter already wore down (almost) their first ring in two weeks, but they’ve been spinning nonstop. I just tried printing in PETG to see if it’s a better material for them. Still comes out perfect.

I scaled them down a bit, since I didn’t need them to be just as big, but the print was still flawless.

a little big for a smaller hand, but the print is absolutely flawless.

Absolutely love this! Super solid print, that comes out looking great.

Quite good. a little smudged at some details, but overall good.

Minor flaws in details, but overall good and cute little cats.

These are so great! Good quality and easy to use.