Search models, users, collections, and posts
Bio
...
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Pioneer Maker
Print successful 123 different models and 1,745 hours
Very nice model. Swapped to a different head and added some shorts plus a name/number. Printed in Bambu Labs PLA Basic Maroon Red.
Share
0
0
0
Nice print as always. Altered the pattern on the back for a more interesting effect.
Share
0
0
0
Very nice model. I scaled this up to 150% (approx. 30cm tall) to match some other brick men I have printed. I also added highlights to the cuffs & added shorts/socks/boots. Changed the head to a different version as well. Name & number added to personalise for friends. Had to sand the connector from arm to body down slightly as the fit was too tight, but this may have been a side effect of scaling the model up.
Share
0
0
0
Another excellent print. Sunlu Silk PLA+ Red Copper & Eryone Standard PLA Black.
Share
0
0
0
Share
0
0
0
Share
0
0
0
Share
0
0
0
Share
0
0
0
Excellent print. Scaled up to 130mm high & 155mm diameter.
Printed in Elegoo PLA Galaxy Peacock Blue
Share
0
0
0
After printing the excellent Ikea Kallax Spool Storage by CtrlSaltDelete I realised it was difficult to see which colours of filament were in the rear of each Kallax cube. I designed this solution, which use brackets & labels/swatches to give the information at a glance. Minimal filament use (only 1g per label/swatch & 8g per bracket).
Ikea Kallax Filament Label System
10
48
Share
0
0
0
Very nice design. One or two small artifacts around the overhangs, otherwise excellent.
Elegoo Matte PLA Navy Blue / Sunlu PLA+ Silver.
Share
0
0
0
Share
0
0
0
Terrific print! Printed at 50% scale. Used Bambu Labs PLA Matte Caramel for the skin colour.
I needed to tweak support settings for the arms as they were prone to fall over mid-print.
I also did a wee bit of customising to add a name/number to the back of the shirt for a surprise Christmas gift for a family member.
Updated 03/02/26: Have now printed a full size version (Jota on the back) and the model is still excellent. Approx. 30cm tall (ruler for scale).
Share
0
0
0
Excellent print. Decided to add a bit of colour in the slicer.
Share
0
0
0
Excellent print as always. Printed at 50% and added a name and number as a finishing touch.
Share
0
0
0
Another excellent print. I added names and numbers to the back for gifts for family members & printed at 50% size. I had to fudge the badge a bit to make it print so small as the printer couldn't cope with printing the fine detail at 50%.
Share
0
0
0
Another Angus club makes it to Makerworld.
Brechin City Football Club coaster
2
0
Share
0
0
0
The post is no longer available
My first attempt at a make from scratch after printing other coasters. My home town team!
Forfar Athletic Football Club coaster
1
1
Share
0
0
0
Fantastic print. Will be passed on to a relative to assist with counting collections at their church. Should save them a huge amount of time. Will boost when have one available.
Share
0
0
0