For FDM minis these are Bonkers. Printed on A1 with 0.4 nozzle. To echo other ratings, you must be very careful when removing supports - may be worth toying with the settings. The sword had to be reprinted because of ham-fisted support removal. I prefer to print these 10% bigger and on silent mode for best result.

leveled the heck out of my mini fridge. Textured top layer is great to keep it in place.

Excellent design, checked it against my mitotoyo calipers with very close tolerance for measuring. Surprisingly good print with no supports. Im pretty abusive with my key chains, and the print held up for a good few months and was used frequently.

absolutely perfect to throw at players - light enough to not poke their eyes out, but heavy enough to throw across the table when they deserve it.

Perfect fit on surface pro 4, hoping to get time to remix with a baby pin on the back for any other board-ops using outdated tablets

NOW THATS UNION BABY

Printed in PLA instead of TPU - still allowed me to be able to use my sunglasses. If this doesn't click in because not all glasses are the same just bust out the soldering iron and you're good to go!