Great filament stand. I have printed a ton of these to use in two filament lockers and am currently printing about a dozen more. Thumbs up to the designer.

Great print. I had to modify the x axis a bit to fit, but works well.

Good print. Upscaled the X axis to accommodate several pamplets.

Perfect print. Makita 18volt series fit perfect in this. Thank you designer.

Great print. This is well designed and strong. I used designers original for 10 inch plates and down scaled for 7.5 inch bowls. Happy with both.

Good print, quick and easy. The pause is helpfully and the wife got a kick out of this.

Fast, clean print. Wife loved it.

Great print, came out well. Alot of waste on a P2S, but you can't get around that.

Great print. Results were good, and shell is true to size. On display next to other ordnance at work.

Simple, quick print. Nice look and funtionality.

Nice clean print face down.

Clamps work well printed in PetG. Thanks designer

Easy simple print. Supports were easy to remove.

Cool print. Easy one plate job that was easy to assemble with a little Teflon lubricant

Came out great. We'll designed and easy to assemble.

Great print. Removal of supports was a bit of work, but we'll worth it.

Great looking. great design, great print. The wife loves these. Printed a set of four in different colors.

Great print, flawless in ABS. Fitment was great, looking forward to drying out some dessicant.

Nice and organized starting point. I had to downsize a bit to keep a single size to fit all spools, as not all spools are created equal; no fault of the designer. Some of the labels pop out of the holders, so just a bit of trimming or super glue did the trick. My suggestion to anybody who prints these...print a couple and check fitment. Determine optimal scaling, then mass print.

Great print, raised colors to allow for condensate drain. Printed a few for my coworker.