Works just as well if not better than the one my wife bought off amazon before I got my printer. I say better because this has more little hooks on it to hang your stuff to dry.

Its a funnel, it funnels washer fluid into the washer fluid tank. Fits Model Y Juniper also. Prints with out issue.

Print these all the time, just be careful what filament you are using as to what filament you are putting them on when drying your filament. I usually just print them in PETG but when I am at the end of a spool this is a nice finish the roll print doing them object at a time. I have had a few warp when drying but I just heat them up a bit and re-stretch and flatten, and this is why I said pay attention to what you are drying and they are on lol. You can get 15 of these on a 256mm plate if you orientate them correctly and leave little space.

I didn't know which one to print as the spool I got is about 199.4mm measured with calipers. Went with the 199, which is pretty tight on the spool but it stays on. Throw it in the dryer and its like a custom fit. Used PETG for the rings.

Nice design. Printed with Bambu PLA Basic Black and Orange, Bambu PLA Matte Dark Blue and White. Bambu PLA Basic Jade White a bit too translucent and allows the orange to come through. First picture should be the one with Basic Jade White .20mm standard as print profile setting but left all other settings alone. The wavy in the upper left of this print is a printer problem and not a design issue and I ended up needing to do manual tramming. Second one is with Bambu Matte White changed profile preset to .08mm High Quality, I switched the preset after noticing the .08mm in the print profile for layer height. Both of these prints used .4 nozzle. Switching preset to .08mm High Quality took it to an over 4 hour print. Sending the good one out to my brother, will be redoing the messed up print from my bed being jacked up.

Printed with out issues.

Prints perfect. Hope my brother likes this along with all of your other prints I have done recently to send him. Still have to print a lot of them for myself. Keep up the awesome designs and work! Bambu PLA Matte Dark Blue Bambu PLA Basic Orange Bambu PLA Basic Jade White

Finally able to rate this. love the bigger size. only printing issue I had was the UP lifted on the first time I printed it but that I attribute to me printing in my garage (~50°F in there) and I forgot to put my fan diverter back and turning the fan down on a P2S. The connection is pretty tight and holds together really well, no need for glue that I found.

Thank you for this, finally no more water all over the floor. I have the LG Wash Tower and it needs the +1” print. highly recommended print if you have one of these machines. Also need to remove the door for the Wash Tower.

Figured it out. First actual functional print ever. saved me some time to print a riser. easy quick print.