Laken

cover

WhatsApp Image 2026-02-13 at 11.36.24.jpeg

WhatsApp Image 2026-02-13 at 11.36.37.jpeg

Titanfall 2 Ronin Prime Sword

1.png

2.png

3.png

4.png

5a0bf383-c022-418d-b67b-906a419a5af6.jpg

840ad065-1f5f-4631-955c-57b2fe974769.jpg

d766e06d-2bc2-4db8-a102-fcfbc38a5757.jpg

5.png

6.png

Helldivers 2 MG-43 Machine Gun

AKMSU Thumbhole Handguard

P1S/P1P/X1C Nordic Vegvisir Fan Cover

P1S/P1P/X1C Lotus Fan Cover

P1S/P1P/X1C Bee Fan Cover

First of all, I wish to give credit for the fact this doesn't need any screws and it's literally printing straight to the assembly. I suggest using PET-G or higher as PLA does wear over time and the joints would loosen.. The model itself and the end result is a FANTASTIC, very high-detail Northstar Prime, but I had to work on it for a few good hours.

No matter what orientation you choose, there will be some support scarring. The one OP used is very good, but you will have to remove a lot of supports and post-process. That, or just paint it all. Here's mine, before paint.

Some joints are weak. I am talking about especially the one between the cockpit and ''abdomen'', then both between the foot and kneecap. To avoid having it fall under its own weight, I took OP's advice but didn't have a glue gun, so the closest thing I had was my (now rekindled) girlfriend's help with some UV-LED nails gel and it worked wonders.

Thanks for the amazing model. I had a blast putting it together, too!
