Search models, users, collections, and posts
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Pioneer Maker
Print successful 143 different models and 538 hours
prints well. used sunlu yellow pla. held up to toddler for about a week before it was stretched and broke. impressive by my standards
Share
0
0
0
great print. used sunlu petg black. everything works as expected. fits together well. fits under foot of printer. the only thing I want to change when I reprint it; is to mirror it so it’ll sit on the left side instead of the right. I have a holder for my build plates there so ideally on the left works best for me.
Share
0
0
0
Share
0
0
0
great print. holding up to my toddler abusing it.
Share
0
0
0
great print. printed as expected. screws fit snug.
Share
0
0
0
Share
0
0
0
prints great. used sunlu petg black. works as intended.
Share
0
0
0
great print. holds plates nicely. used sunlu pla 2.0 black.
Share
0
0
0
prints great. used sunlu pla. 2.0 white. supports came off smooth. everything lines up great. settings came dialed in perfectly. highly recommend. wife is happy to have these for her pump set up since she’s always on the move around the house and work and so on.
Share
0
0
0
I printed this with sunlu petg. great print. exactly what I was wanting. only issue I had was the vents were tight and ended up breaking a tab when I tried it. other then that amazing design
Share
0
0
0
great print. used sunlu pink pla 2.0+. some of the supports were difficult to get off around the hands and face. other then that great print and my kid loves it.
Share
0
0
0
great print. fits the wipers perfectly. printed with sunlu petg. only thing I would change is a thicker handle but that’s me and my arthritis hands. other then that highly recommend.
Share
0
0
0
prints great. first attempt was rough but my filiment wasn’t dry. used sunlu+ 2.0 pink after I dried it and came out great. top of egg was a little rough but doesn’t affect it one bit.
Share
0
0
0
great print. used sunlu petg. snug and holds perfectly
Share
0
0
0
top insert didn’t fit without a lot of sanding and super glue. other then that smooth print
Share
0
0
0
great print. fits snug and goes together smoothly
Share
0
0
0
Share
0
0
0
great print. does exactly as expected. clean brim on print that separates easily. printed in bambu pla black matte.
Share
0
0
0
amazing print. just wish the lid had better lip to stay secured
Share
0
0
0
good scraper. tolerance on spot to lock onto door slightly loose for my liking
Share
0
0
0