printed great!

Haven't used it yet so I dont know how strong or well it will hold up, but it printed and fits great.

great file, no issues.

nice print, I wish I had read the info first as I struggled to put the eyes in before building the eyes. once I read the info it went together quick and less painful.

All in all, nice print. the half pod didnt stick to the bed in the corner, zero other printing issues. wish there were more control over colors on this one like back wall color different than sides like some of the other models. very cool tho!

lid is a little jagged but this thing is awesome!

I needed a ruler to do an alignment on an rc car, printed to match the alignment tools, very precise and printed great first time in pla+

Decent print, a little unrefined. The top edge comes out a little jagged and the center pin mount is wonky, not that its needed on my application. its missing the vertical oval recesses, but a few minutes with a dremel fixed that. All mounting holes need to be drilled before you can thread them, unless you plan on using self tapping screws, you cannot use fine threaded rc screws that come with these cars without clearing out the holes, I stripped 3 and reprinted to learn that lesson. Still a great file, I printed in petg and am very happy with end result, just know you gotta do a little work.

its decent, it helps get you close, but without the vertical sides being tied together, you won't get a proper toe alignment. the camber is pretty accurate tho.

they work, file printed great

looks great!

printed fine

printed great

printed nicely

Amazing model, work great, very minimal stringing, and they fit nicely without glue needed. Thanks for the file, I'll be sure to boost!

These are AMAZING!!! thanks again for making these for me, I had to order a .2 nozzle so sorry it took me so long to print and review. I boosted you too! Well deserved!

They printed well, the tpu tire file fits these perfectly as do the pla toyos... first one I let sit overnight before trying to remove the supports- DONT do that! The second I printed I pulled at the finish of the print and they were relatively easy. The hex in rear is the right size but its hard to clear the supports media out of them so you'll need to spend some time with a file and dremel, but they came out nicely.

great print, 1/10 was a lil too big for my drift/touring car, gonna reprint in 1/12 scale. very detailed, supports are hard to remove and they require sanding/finishing but it came out great!

printed fine

huge fan of these, printed in silver petg, the rear hex isn't great and needed a bit of sanding to get it to fit but they are strong and look good...