Search models, users, collections, and posts
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Focusrite Scarlet 4i4 Fourth Generation angled desk stand. I found an under desk mount that I liked, flipped it upside down and added the bass portion in Tinkercad. It's a 22 degree angle. I have some cable management under the XLRs in the front in case you want to route your cables to the back of the unit. There's some space to feed a standard size XLR through. But, the back is mostly flat in case you want to clamp it to a desk with C-Clamps, spring clamps, or some other option.
Focusrite Scarlett 4i4 Gen 4 Under Desk Mount
10
26
Share
0
0
0
Share
0
0
0
This is super cute. The smaller pieces like ghosts, headstones, and pumpkins don’t stay in tight. So, if it’s just a sitting decoration it’s not a big deal, but if it’s somewhere where, like on a office desk it will get picked up or admired often, you’ll lose the pieces.
Share
0
0
0
This is amazin! the way the batteries click in place is soooo satisfying.
Share
0
0
0
My first upload. It's a half molle panel for the lid of a Pelican 1510 case. The profile is setup for Generic PETG. I had the standard lid organizer, but needed a bit more space on one side. So, I designed this to fit half of the lid, so I still had some where to organize small items, but had some space for larger things in the bottom of the case to stick up a bit more.
If you use this I'd love to hear your thoughts and feedback.
Pelican 1510 Half Panel Lid Organizer
79
320
Share
0
0
0
Share
0
0
0
I’ve printed 5 of these so far(t) and they are just perfect!!
Share
0
0
0
The legs tend to be inward if you scoot your deck around often. So I may try to redesign it with a different tilt to the legs. But overall, this is such a great design and a much bigger improvement on the original stand. Thank you.
Share
0
0
0
Share
0
0
0
Works well. Some are a bit tight because they don’t all come out 100% the same. But luckily there are a few so you can swap.
Share
0
0
0
Pretty nifty li’l caliper. I’m always needing a quick measurement of something when I’m out and about so this will be perfect!
Share
0
0
0
Bought an A1 yesterday and got a roll of filament at the store to start tinkering. I then ordered some filament off Amazon only to realize it was replacement filament. I started looking at adding spools to my Amazon order only to wonder “Could I just print this?” And, yea, this is a great model and has already saved me money. Thanks!
Share
0
0
0
No more data